 Check out the bookstore at IRBS.com |
|
|
|
|||||
|
||||||
Subject: [worldcruising] Re: Mast steps
truelove39@XXX.XXX
Date: Sun Feb 04 2001 - 09:17:26 EST
I installed the ABI folding steps and I'm very happy with them. Damage
Control makes a similar step, except they come in different "sizes" to fit
various mast diameters. I used 1/4" aluminum rivets - be aware that two
lengths may be required as the thickness at the bottom holes is less than at
the top. I was careful to punch the steel mandrels out after riveting, and
sealed the holes with silicone. I originally contemplated doing this job "in
the air," and was happy that I did it with the spar on the hard instead. It's
a good idea to measure clearances to shrouds, etc. prior to unstepping the
mast in order to avoid interference near the tangs. I had to offset a couple
of steps in this area to provide clearance. Regarding spacing, I used the
minimum recommended (18") because my 1st mate was short; I was happy I did,
because although I'm 6'+, I would not want it to be greater than that.
John
"Truelove" - Westsail 43
Evert Volkersz <evolkersz@XXX.XXX>
> I am planning to install permanent, folding mast steps so I can climb my
> mast. Any suggestions on brands, spacing, installation?
------------------------ Yahoo! Groups Sponsor ---------------------~-~>
eGroups is now Yahoo! Groups
Click here for more details
http://click.egroups.com/1/11231/1/_/508787/_/981296254/
---------------------------------------------------------------------_->
=====================================
to unsubscribe email to: worldcruising-unsubscribe@onelist.com
|