Next message: janice142: "Re: T&T: Honda EU2000i source?"
Just completely replaced my Island Gypsy 32 windows We did not drill holes but beveled the lower corner edge for a professional job.
jack
Sea Spirit
-------------- Original message --------------
From: "Dale Klahn" <>
> I've pulled the three front windows off the helm station area of my 32'
> Island Gypsy and am repairing some rot, coating with CPES, replacing the
> glass, and repainting them. The two outside (port and stbd) windows
> have drain holes drilled at the bottom on the low side to allow the
> small amount of water that would collect there to drain away. I'm
> wondering if there is a better way to drain these windows other then
> just drilling another hole through the frame or if not putting the drain
> hole in would be any worse. These windows have been repaired before
> from rot at this drain hole location.
>
> Dale Klahn
> _______________________________________________
> http://lists.samurai.com/mailman/listinfo/trawlers-and-trawlering
>
> To unsubscribe or modify your subscription options (get password, change email
> address, etc) go to:
> http://lists.samurai.com/mailman/options/trawlers-and-trawlering
>
> Trawlers & Trawlering and T&T are trademarks of Water World
> Productions. Unauthorized use is prohibited.
_______________________________________________
http://lists.samurai.com/mailman/listinfo/trawlers-and-trawlering
To unsubscribe or modify your subscription options (get password, change email address, etc) go to: http://lists.samurai.com/mailman/options/trawlers-and-trawlering
Trawlers & Trawlering and T&T are trademarks of Water World
Productions. Unauthorized use is prohibited.
