|
|
|
|
|||||
|
||||||
Subject: Re: Fluxgate compass
From: George Huxtable (george@XXX.XXX)
Date: Sat Feb 02 2002 - 19:21:39 EST
Lu Abel said-
>If one plots deviation as a function of compass direction it should look
>like a sine wave (for fiberglass and wood boats at least, not sure about
>steel). If the sine wave is "off center" (ie, the plot shows more westerly
>deviation that easterly or vice versa) it is an indication that the lubber
>line of the compass is not aligned with the ships keel.
>
>After I learned this fact I plotted the deviation table for my 36' sailboat
>and -surprise- it was uneven. Even though it's a high quality boat, the
>compass had been fastened to the steering pedestal with the lubber line of
>the compass pointing about 2 degrees to starboard. Hard to discover, easy
>to fix once I had done so.
>
>What I suspect that any decent deviation-determining software does is
>simply to even out the deviation readings so the sine-wave is "balanced."
>
>Lu
==================
If a plot of deviation shows an "off-centre" average, as Lu describes, that
can arise from two possible causes,
1. As he says, a misalignment of the sensor with the axis of the vessel.
2 An asymmetrical distribution of ferrous material, subject to induced
magnetism.
Unfortunately, the usual sail-in-a-circle technique for correcting compass
errors is quite unable to correct for errors of this type, or even to
determine that they exist at all.
George Huxtable.
------------------------------
george@XXX.XXX
George Huxtable, 1 Sandy Lane, Southmoor, Abingdon, Oxon OX13 5HX, UK.
Tel. 01865 820222 or (int.) +44 1865 820222.
------------------------------
|