Next message: Lew Hodgett: "Re: lv-ab: DIY Dog Ramp"
I know. But that's what was sitting there at Lowes. There is one minor
defect on one side. As to smoothness, I could not tell any difference
between the two sides so I placed the single defect inside faced with
adhesive. The aim was low cost so I didn't even consider marine plywood.
Ron
----- Original Message -----
From: "Lew Hodgett" <>
To: <>
Sent: Monday, March 03, 2008 11:43 PM
Subject: Re: lv-ab: DIY Dog Ramp
|
|
| Ron Rogers wrote:
|
| > I wasn't clear. We used 3/8" CDX, smooth both sides and laminated
| the two
| > pieces of ripped material. So that equals 3/4".
|
| That you laminated two pieces together to get 3/4 was clear.
|
| What has me curious, how did you find 3/8" CDX, smooth both sides?
|
| By definition, "C" & "D" specs surfaces with voids.
|
| Lew
|
___________________________________________________________________________
||| The Live-Aboard List : send a "subscribe" or "unsubscribe" request ||
||| in body of message to: ||
___________________________________________________________________________
|| The Live-Aboard List : send a "subscribe" or "unsubscribe" request ||
|| in body of message to: ||
